![]() "Because $10,000 $5,000 $1,000 is too much to pay for an autopilot, especially one that doesn't do exactly what you want."Īn Unmanned Aerial Vehicle (UAV, colloquially known as a "drone") is basically an aerial robot. Empty the tank and drain the pipes if the aircraft needs to be transferred or will not be used for an extended… Read more… ③Wipe the surface of the aircraft to remove potion stains and mud. Place the empty tank in the aircraft and start spraying until all pipes are drained, avoiding damage to other devices during transportation or storage. ②Fill the tank with clean water and start spraying to wash off residual soapy water or the laundry powder in the spraying system. Start spraying to clean pesticide residues in the spraying system. ①Fill the tank with soapy water or the laundry powder. The equipment needs to be cleaned after using corrosive liquids such as pesticides. Here are some maintenance methods divided into two situations: To prolong the lifespan of your drone, regular maintenance ensures that the device performs at its best in future operations with fewer malfunctions and improved efficiency. Posted by Assembly Dronenthusiast on Augat 6:08pm I set the servotester knob to display 10Amps of current in the Turnigy Power Analyzer, but very soon the… Read more… I mounted the two 100W 1Ohm wirewound resistors which were already in aluminium heat sinkable cases, on an additional large aluminium heat sink with a fan. ![]() To control the brushed 30Amp ESC, I used standalone cheap servo tester. Initially I thaught of using two 100Watt 1Ohm resistors in parallel and energizing them via 30Amp brushed motor ESC connected to the output of the 3DR Power module (power tapped from same points where 4 ESC's are soldered. And calibration done via this old conventional is not proper and current reported in mission planner while the copter is in air, is in error by 1-2amps and that makes lot of error. I have observed many many times during conventional menthod of current calibration of the 3DR Power module using arming the copter and motors that the current displayed by the power anlyzer is not stable and fluctuating by 1-2Amps or even higher. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |